KOMPBERG®️ BSDF250 Screw Compressor

Refrigeration dryer DRYBERG®️ RF52/AC equals to DRYPOINT®️ RA3000/AC Refrigeration dryers with Energy Saving Impulse Technology and Thermal Mass With the introduction of RF, the new generation of energy-saving refrigeration dryers, BERG not only renews its product offering for the compressed air treatment but also reinterprets the concept of thermal storage operation, that made the international success of the RF dryers. The new Impulse Technology offers important advantages in terms of energy saving, reliability and operating costs as the RF dryer is able to adapt itself to the real needs of the compressed air system. The regulation system of the dryer controls the dryer operation granting the most energetically effective method of compressed air drying, achieving high energy saving and ensuring at the same time an excellent dew point stability also in dynamic conditions. IMPULSE TECHNOLOGY FOR HIGH/MEDIUM AIR FLOWS The refrigerant compressor is permanently ON to achieve a perfect control of the dew point. The microprocessor controls through “impulses” the opening and closing of a solenoid valve installed on the suction pipe of the refrigeration compressor, in partial load conditions then only a small portion of the nominal refrigerant flows through a by-pass calibrated orifice of the solenoid valve to the compressor. In partial load conditions the compressor compresses less refrigerant than at peak load and therefore it consumes less energy (refrigerant flow control technology). THERMAL STORAGE OPERATION FOR LOW AIR FLOWS The refrigerant compressor cycles ON/OFF for maximum savings and reliability. Since the refrigeration capacity is greater than the load, the excess capacity cools the all-in-one exchanger that acts like a thermal storage. • For high/medium flows, the dryer applies the Impulse Technology to regulate its drying capacity. • For low air flows, the dryer utilizes the “thermal storage” operation.

Compressed air filter PUREBERG® F46(Type)W ,2760 Nm3/h at 7 bar General filter, Fine filter, Superfine filter, Activated carbon filter Innovative features mean outstanding performance without compromise  Compressed air filter PURBERG® housings have been developed for high-efficiency removal of solid particles, water, oil aerosols, hydrocarbons, odour vapours from com­pressed air systems. To meet the required com­pressed air quality appropriate filter element (G, F, S, A) must be installed into the filter housing. Housing prevents condensate from being picked up and "car­ried over" into the airstream. The BERG compressed air filter technolo­gy guarantees low operating costs, long service life, outstanding process reliability, and safe filtration. 

Efficient Moisture Removal: PUREBERG F46WW Water Separator for air Compressors A water separator, also called a condensate separator, is a device that removes moisture and water from an air flow. In the area of air compressors and compressed air systems, the water separator is important to ensure that the air remains dry. Moisture in the compressed air can otherwise lead to problems such as rust, blocked lines and damage to machines. The water separator PUREBERG® F46WW, (2760 m3/h at 7 bar) is a widely used example in the industry. The water separator works through various mechanisms to separate the condensate from the air. In most cases it uses centrifugal force or gravity to remove the water from the airflow. As the moist air flows through the separator, the water droplets are pulled out of the air by these forces and collect at the bottom of the separator. From there, the accumulated water can be removed from the system either manually or automatically. There are different types of water separators, including condensate separators for air compressors, compressed air lines or industrial applications. Choosing the right water separator for the device depends on various factors. These include: flow rate, pressure, ambient temperature and the specific requirements of the program. In summary, the water separator is very important in compressed air systems. It helps make the air cleaner, improve operations and make machines last longer. Water separator with comprehensive rate and outstanding efficiency PURBERG® water separator have been developed for high-efficiency removal of bulk liquids from compressed air and vacuum systems up to 20 bar. Inside the housing, there is an insert with vanes that creates a controlled rotation of the air. As a result of centrifugal action liquids (water, oil) and large particles are forced to the housing wall, slowed down and accumulated at the bottom of separator housing as condensate. The turbulent free zone in the lower part of the filter housing prevents condensate from being picked up and "carried over" into the airstream. To discharge condensate from the F-WW water separator it is essential to install automatic or electronic condensate drain. Function of water separator Compressed air enters the water separator through the curved inlet and then specially shaped guide vanes ensure a special rotational movement at high speed and force the compressed air into a circular movement. After the resulting centrifugal forces direct the water droplets to the outside of the filter housing, the droplets flow down into the collection chamber due to gravity. Shielding the collecting area Calms the air flow in this area in order to effectively avoid whirling up and entrainment of already separated liquids. In water separator a specially designed riser tube prevents particle transfer to the upward rotating flow of the compressed air, which has largely been cleaned of condensate. The innovative water separator rectifier leads the compressed air to the outlet and reduces flow losses to a minimum.

QWIK-PURE® simply grows with you Each QWIK-PURE® model can be easily expanded or scaled down according to current needs. This creates decision-making reliability and additional safety. And because exactly the same cartridge is used in all models, procurement and stock-keeping become even easier. Qwik-Pure represents a radical rethinking of oil-water separation, offering safe, compatible, certified, ergonomic, fast, modular, clean and universal functions. It meets all hygienic, efficient, clean, safe and modular requirements, making it the main feature of the new Qwik-Pure generation.

BEKO condensate drain BEKOMAT® 20BEKOMAT® 20 | 20FM for Filters and water separators The BEKOMAT 20 is a strong condensate drain designed for use in water separators and air filters. It is suitable for oil-lubricated plants as well as oil-free compressors. The control panel is accessible from the top and the front. It has a plastic housing with integrated aluminum condensate container. The BEKOMAT 20 FM with integrated filter management is a cost effective monitoring solution for the service filters element. Here are some advantages and uses of the BEKOMAT 20: Efficient condensate drainage: The BEKOMAT 20 is designed to effectively remove condensate from compressed air systems, ensuring optimal performance and preventing damage to downstream equipment. Energy-saving: The unit operates based on demand, meaning it only activates when condensate needs to be drained, helping to reduce energy consumption. Easy maintenance: The BEKOMAT 20 is designed for easy installation and maintenance, making it user-friendly for operators. Reliable operation: Beko Technologies is known for producing high-quality products, and the BEKOMAT 20 is no exception, offering reliable performance in industrial applications.  BEKOMAT 20 Applications:Industrial compressed air systems: The BEKOMAT 20 is commonly used in industrial settings where compressed air is a critical component of operations, such as manufacturing plants, automotive facilities, and food processing plants. Air compressors: The unit can be installed in conjunction with air compressors to ensure efficient condensate removal and protect the integrity of the compressed air system. Pneumatic tools and equipment: The BEKOMAT 20 can help maintain the performance and longevity of pneumatic tools and equipment by preventing moisture buildup in the air supply. Overall, the BEKOMAT 20 is a reliable and efficient condensate drain unit that offers several advantages in maintaining the performance of compressed air systems.