BEKO condensate drain BEKOMAT® 3 CO EX
Condensate drainage without loss of compressed air
If a float arrester leaks, high costs arise as a result of leaks. Time-controlled solenoid valves also cause compressed air losses. During the valve opening expensive compressed air escapes unused into the environment. In contrast, a condensate drain with electronic level control guarantees draining without compressed air, ie energy loss. This not only saves energy and costs, but also CO 2 emissions.This is a fantastic condansate drainage without loss of compressed air.
Technical data of BEKOMAT 3 CO EX
BEKOMAT |
BEKOMAT 3 CO EX |
Compressor Capacity [m³/min] |
100 |
Voltage |
12 VDC |
Operating pressure [bar] |
0.8 - 16 |
Temperature [°C] |
+1 bis + 60 |
Condensate feed |
3 x G 3/4 |
Dimenstions B x T x H [mm] |
160 x 193 x 255 |
Weight [kg] |
ca. 5,0 |
Application |
Oil-contaminated condensate | oil-free, often aggressive condensate |
Function Of BEKOMAT 3 CO EX
Picture example, BEKOMAT® 3 EX
Empty state:
Condensate drips through the inlet opening 1- and collects in the container 2- The diaphragm valve 5- is closed because the pressure equalization across the valve diaphragm via the pilot line 3- and the solenoid valve 4- 5- takes place. The larger area above the membrane causes a high closing force. The valve seat remains closed without leaks.
Filled state:
If the container 2- is filled with condensate so that the capacitive level sensor 6- reports a signal at the maximum point, the solenoid valve is switched and the area above the valve membrane is vented. The valve membrane lifts off the valve seat 7-, the overpressure in the housing pushes the condensate into the outlet line 8- The valve is closed leak-free before the compressed air escapes. If the condensate drain is disturbed (blocked drain line, defective membrane), the alarm mode is triggered after 60 seconds. The LED flashes, a fault message can be picked up as a potential-free signal via the alarm relay. With Ex devices this is possible via a built-in optocoupler and a switching amplifier. In this state, the solenoid valve is opened for 7.5 seconds every 4 minutes. A BEKOMAT® filled in a pressureless state is automatically alarm-free again under pressure. The drained condensate is now sent to the ÖWAMAT® oil-water separator for disperse condensate for treatment. In the case of stable emulsions, we recommend the BEKOSPLIT® splitting system for almost waste-free processing. Both systems offer legally compliant process technology for treating your compressed air condensate.
Downloads
Technical Data BEKOMAT 3 CO EX , PDF( Size: 702 KB )
Data sheet BEKOMAT 3 CO EX , PDF( Size: 154 KB )
Technical Data sheet of BEKOMAT 3 CO EX , PDF( Size: 63 KB )
Catalog BEKOMAT 3 CO EX , PDF( Size: 509 KB )
Catalog PUREBERG , PDF( Size: 2 MB )
Contact us
E-mail:Kundenservice@berg-kompressoren.de